Expobar G-10 Wartungshandbuch PDF herunterladen (Seite 22)

G-10

CLEANING AND CARE

Cleaning the gasket and shower plate

WARNING!

Take special care to avoid scalding when

performing this cleaning operation, as the

hot water used to clean the gasket will

spill over the sides of the porta-lter.

WARNING!

Do not fully tighten the porta-lter. If fully

tightened, high-pressure water may spray

out and cause scalding or serious injury.

When placing the porta-lter lled with grinded coffee into the brewing group, left overs will accumulate in the

closing surface. If these remains are excessive it can prevent a good closing between the porta-lter and the

group head.Moreover, these remains can even block the dispensing of water through the group head.

To prevent this perform the following cleaning:

Place the cleaning membrane in the lter basket (without detergent).

Insert the porta-lter in the group head, but do not tighten fully (the porta-lter should be loose).

Press the Continuous Dispensing button on the button panel.

Make an opening-closing movement of the porta-lter in place without closing it. Water will now ow

around the porta-lter, owing through the closing surface and cleaning it.

Cleaning the gasket

Cleaning the shower plate

Remove the porta-lter from the group head.

Clean the shower and gasket with a soft brush to remove any coffee remains.

Shower plate

Leftover coffee

requiring cleaning

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 79 80

Keine Kommentare

Expobar G-10 Wartungshandbuch Seite 22